8.27.11 Final Plat Requirements

(1) A final plat shall be prepared for all developments. Each plat shall consist of a sheet of approved mylar having outside or rim line dimensions of twenty-four (24) inches by thirty-0six (36) inches. The borderline of the plat shall be drawn in heavy lines, leaving a margin of at least one and one-half (11/2) inches on the left-hand side of the sheet for binding, and at least one-half (1/2) on the other three sides of the sheet. The plat shall be so drawn that the top of the sheet is either the north or east, whichever accommodates the drawings best. All lines, dimensions, and markings shall be made on the mylar with approved waterproof black "India Drawing Ink", or equivalent. Font size shall be ten (10) points or larger. The actual map shall be drawn to a scale within the range of one inch equals ten (10) feet (1"=10'), to one inch equals one hundred feet (1"=100'), unless approved otherwise by the planning department. Details and the workmanship on finished drawings shall be neat, clean cut, and readable. A poorly drawn or illegible plat is sufficient cause for rejection. The final drawings or plats shall contain the following information: (a) Subdivision name and the general location of the development; (b) A north point and scale on the drawing and the date; (c) Accurately drawn boundaries, showing the proper bearings and division, properly tied into state plane coordinates and tied to no less than two (2) known section monuments. These lines should be heavier than street and lot lines to clearly define said development boundaries. Also provided with the plat shall be a closure sheet of the subdivision boundary as well as for each lot within the subdivision; (d) The names, widths, lengths, bearings and curve data on center lines of all proposed public streets, alleys or easements; also the boundaries, bearings and dimensions of all portions within the development, as intended to be dedicated to the use of the public; the lines, dimensions, bearings, and numbers of all lots, and other parcels reserved for any reason within the development. All lots and parcels are to be numbered consecutively under a definite system. All proposed streets shall be named or numbered in accordance with the street naming and numbering system of the Town of Daniel; (e) The location of existing water courses; (f) The location of all required monuments; (g) The description and locations of all monuments set and established by the Town of Daniel, the county or the United States government that are adjacent or near to the proposed development; (h) Address block with addresses as assigned by the GIS department; (i) A notice of potentially harmful conditions where such conditions exist; (j) A ten-foot (10’) public utility easement on all sides of the lot. (k) A form of certification for the following: (i) Owner's dedications; (ii) Owner's surveyor's certificate of accuracy of survey; (iii) County surveyor's approval; (iv) Planning Commission approval; (v) Omitted. (vi) Mayor's approval of the plat and the acceptance of dedications of public lands, streets and easements; (vii) County fire marshal's approval; (viii) Town attorney's approval as to form; (ix) Wasatch County health department approval; (x) Wasatch County affordable housing approval; (xi) Utility will-serve letters; (xii) Wasatch County weed board approval; (xiii) Omitted; (xvii); (xviii) Engineering department approval; (xix) Notary public's acknowledgement.