10-10-2 R2 (MULTI-FAMILY RESIDENTIAL)

The purpose of the R2 Zone is to provide residential areas that will accommodate the development of dwelling types from single-family through multi-family units with their associated necessary public services. It is also to provide an orderly transition from less intensive, lower density uses to more intensive, higher density uses. Refer to the table below for site development standards. Minimum Lot Area for One Building Dwelling Minimum Lot Area for Group Dwelling Minimum Lot Width Minimum Front Yard Setbacks TABLE 10‐10B SITE DEVELOPMENT STANDARDS FOR R2 7,500 plus 2,000 square feet for each dwelling unit (including bachelor or bachelorette dwelling) in excess of two in each building; plus 1,000 square feet for each occupant in excess of four in each dwelling unit. 7,500 square feet for each building, plus 2,000 square feet for each dwelling unit (including bachelor or bachelorette dwelling) in excess of two in each building; plus 1,000 square feet for each occupant in excess of four in each dwelling unit. 40 feet 25 feet, except average where 50% frontage is developed, but not less than 20 feet. Side Yard Setbacks for the Main Building Side Yard Setbacks for an Accessory Building Side Facing Street on Corner Lot Rear Yard Setbacks Lot Coverage Density One building dwelling and group dwelling: 8 feet with total width of two required yards of not less than 18 feet, plus 1 foot each side for each 1 foot main building is over 35 feet Other main building: 20 feet each side, plus 1 foot each side for each 1 foot building is over 35 feet. 8 feet, except 1 foot if located at least 6 feet from rear of main building, but not closer than 8 feet to dwelling on adjacent lot. 20 feet, except average where 50% frontage is developed, but not less than 15 feet. Main Building: 30 feet Accessory Building: 1 foot, except 8 feet where accessory building rears on side yard of adjacent corner lot. No accessory building or group of accessory buildings shall cover more than twenty‐five percent (25%) of the rear yard area. Group dwellings shall be considered as one building for the purpose of front, side and rear yard requirements, the entire group as a unit requiring one front, one rear and two side yards as specified for dwelling structures. The minimum distance between structures shall be 10 feet for single‐story buildings, 15 feet for two‐story buildings and 20 feet for three or more story buildings.