10-6-13 ACCESS REQUIREMENTS FOR OTHER THAN RESIDENTIAL LOTS

1. Access shall be provided to meet the following requirements: a) Not more than two (2) driveways shall be used for each one hundred (100) feet or fraction thereof of frontage on any street. b) No two (2) driveways shall be closer to each other than twelve (12) feet, and no driveway shall be closer to a side property line than five (5) feet. c) Each driveway providing access to a single lot shall not be more than thirty-five (35) feet wide, and each driveway providing access to two lots shall not be more than fifty (50) feet wide per one hundred (100) feet of frontage, measured at right angles to the center line of the driveway, except as increased by permissible curb return radii. The entire flare of any return radius shall fall within the right-of-way. 2. No driveway shall: a) be closer than twenty (20) feet to the point of an intersection of two property lines, and b) be closer than fifty (50) feet to the right-of-way line of any road or street corner, and c) extend across any property line. d) violate any conditions as shall be set forth in “Regulation for the control and protection of state highway right-of-ways” by Utah Department of Transportation. 3. In all cases where there is an existing curb and gutter or sidewalk on the street, the applicant for a permit shall provide a parking strip, with a minimum width of ten (10) feet, along the entire frontage of the property, except for the permitted driveways. On the street side of the parking strip a concrete curb shall be constructed, the height and type is a six (6) inch high back, unless another specification has been approved or has been waived by the Planning Commission. 4. In Planned Unit Developments (when required) and subdivisions that have a density greater than one (1) acre lots, and there is no existing curb and gutter or sidewalk, the applicant shall install a parking strip, sidewalk, curb and gutter, unless this requirement is waved by the Planning Commission.